MIL-PRF-62368C(AT)
ANSI/SAE AS478
-
Identification Marking Methods (DoD Adopted)
(Copies of these documents are available online at www.ansi.org or from ANSI Customer
Service Department, 25 W. 43rd Street, 4th Floor, New York, NY 10036.)
ASTM INTERNATIONAL
ASTM B633
-
Standard Specification for Electrodeposited Coatings of Zinc
on Iron or Steel (DoD Adopted)
(Copies of these documents are available from www.astm.org or ASTM International, 100 Barr
Harbor Drive, West Conshohocken, PA 19428-2959.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event
of a conflict between the text of this document and the references cited herein, the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article
inspection in accordance with 4.3.
3.2 Materials. Materials used shall be in accordance with the manufacturer's materials
specifications for gearhead motors. The materials shall be capable of meeting all the operational
and environmental requirements specified herein (see 4.5.1).
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled,
recovered, or environmentally preferable materials should be used to the maximum extent
possible provided that the material meets or exceeds the operational and maintenance
requirements, and promotes economically advantageous life cycle costs (see 4.5.1).
3.2.2 Age sensitive materials. The use of age-sensitive elastomers, as defined by
ANSI/SAE AS1933, shall be identified and controlled in accordance with that standard
(see 4.5.1).
3.2.3 Gearing. All gearing shall be of the necessary materials, finishes, and precision to
provide reliable performance as outlined herein (see 4.5.1).
3.2.4 Lubrication. The unit shall be lubricated with grease conforming to
STANAG 1135, method G-354 or equivalent and shall not require lubrication during the service
of the assembly (see 4.5.1 and 6.4).
3.2.5 Cover and mounting flange. Material shall be suitable for the intended purpose.
Non-corrosion metal resistant materials shall be zinc plated in accordance with ASTM B633,
service condition (SC 8) (minimum), type II or equivalent (see 4.5.1).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business